297 - Single Coated Fiberglass Cloth

Covalence/Tyco

E-Mail this datasheet

FEATURES

Std Roll Length: 36.00 yards
Adhesion to backing/carrier=62 oz./in. (PSTC-1)
Weight=8.1 oz./sq.yd. (ASTM D-1000)
F.A.R. 25.853 (a) 60 Sec. Vertical Burn Exiting Time=0 sec., Burn Length= 0.25 in., Drip Exiting= No Drip
F.A.R. 25.855 (d) 30 Sec. At 45° Angle Exiting Time=0 sec., Burn Length= None, Drip Exiting= 0 sec

ADVANTAGES

Ease of installation
Accommodates angles and turns
Glass cloth design resists flame penetration for safety
High conformability
High tensile strength
Aggressive adhesive system
Creep resistance maintains seal under load

APPLICATIONS

Cargo pit applications
Seam sealing (taping) and repair of cargo compartment liners for use on covering pins/rivets where high adhesion and flame resistance is critical

MARKETS SERVED

Aircraft
Industrial

COLORS

White

GENERAL INFORMATION

297 is an 8 mil fiberglass cloth tape used to seal seams, cover pins/rivets where high adhesion and flame resistance is critical, and is also used to repair cargo compartment liners.

PRODUCT CONSTRUCTION

	Type	Mil Thickness

Backing	Fiberglass	8.00
Adhesive (unwind)	Rubber (synthetic)
Liner Type (inner)	Polyethylene (blue)
Thickness (total)		8.00

PRIMARY PHYSICAL PROPERTIES

	Unwind Side	Liner Side

Adhesion-to-Steel - 180° Peel	70.00 oz/in
Adhesive Activation	Pressure
Tensile Strength	143.00 lbs/in
Elongation Percent	7.00%
Testing Info: Adhesion to steel: PSTC-1; Thickness, Tensile strength; ASTM D-1000

SECONDARY PHYSICAL PROPERTIES

THERMAL / ELECTRICAL PROPERTIES

Minimum Application Temperature	40°F
Minimum Service Temperature	0°F
Maximum Short-Term Temperature	250°F
Flame Resistant	Yes

The physical properties listed are typical values and are not to be considered as specifications. Our suggestions for use are based on tests we believe to be reliable. However, the purchaser must carry out their own tests to determine the suitability of the product for their internal use. Information is given in good faith, but without warranty.
It is essential, as with all pressure-sensitive tapes, that the surface to which the tape is applied be clean, dry and free of grease and oil.
Shelf life from date of manufacture is based on the product being stored at 70°F(21°C) / 50% relative humidity out of direct sunlight.
Specification compliance is dynamic and should only be used as a general guide. Always confirm that the tape you are interested in currently complies with all specification requirements. Please verify that the product number that you select is available in the proper size and color to meet your specification.