K102R - Polyimide Tape

Saint-Gobain

E-Mail this datasheet

FEATURES

Std Roll Length: 36.00 yards
High temperature resistance
Excellent mechanical & electrical properties
Excellent dielectric strength
High conformability
Resistant to solvents
Acrylic adhesive can be thermoset
Outstanding resistance to cut through, impact & abrasion resistant

ADVANTAGES

APPLICATIONS

Gold finger connector wave solder protection
Solvent & water based fluxes
Various electronic assembly
Electrical insulation applications

MARKETS SERVED

Electrical
Electronics
Industrial
Printed circuit board

COLORS

GENERAL INFORMATION

K102R is a 2.5 mil, polyimide tape with a clear, electrical grade, acrylic pressure sensitive adhesive on one side. It was constructed to fill the requirements of a high performance thermosplastic polyimide backing materials. K102R was designed to fill the need of non silicone adhesive gold finger connector wave solder protection.

PRODUCT CONSTRUCTION

	Type	Mil Thickness

Backing	Polyimide	1.00
Adhesive (unwind)	Acrylic	1.50
Thickness (total)		2.50

PRIMARY PHYSICAL PROPERTIES

	Unwind Side	Liner Side

Adhesion-to-Steel - 180° Peel	28.00 oz/in
Adhesive Activation	Pressure
Tensile Strength	25.00 lbs/in
Elongation Percent	50.00%

SECONDARY PHYSICAL PROPERTIES

UV Resistant	Yes
Solvent Resistant	Yes

THERMAL / ELECTRICAL PROPERTIES

Minimum Application Temperature	20°F
Minimum Service Temperature	0°F
Insulation Class	155.00°C
Direct Electrolytic Corrosion Factor	1.00 Factor
Dielectric Strength	7000.00 volts

The physical properties listed are typical values and are not to be considered as specifications. Our suggestions for use are based on tests we believe to be reliable. However, the purchaser must carry out their own tests to determine the suitability of the product for their internal use. Information is given in good faith, but without warranty.
It is essential, as with all pressure-sensitive tapes, that the surface to which the tape is applied be clean, dry and free of grease and oil.
Shelf life from date of manufacture is based on the product being stored at 70°F(21°C) / 50% relative humidity out of direct sunlight.
Specification compliance is dynamic and should only be used as a general guide. Always confirm that the tape you are interested in currently complies with all specification requirements. Please verify that the product number that you select is available in the proper size and color to meet your specification.